当前位置: > 投稿>正文

midships是什么意思,midships中文翻译,midships怎么读、发音、用法及例句

10-04 投稿

?midships

midships 发音

[['midʃips]]

英:  美:

midships 中文意思翻译

常见释义:

adv.在船中央部

midships 词性/词形变化,midships变形

原型:midship

midships 短语词组

1、amidships or midships ─── 船中

midships 相似词语短语

1、ludships ─── 路德希普

2、midship ─── adj.船体中部的;n.船体中部

3、sibships ─── n.兄弟姊妹;血亲关系

4、windships ─── 帆船

5、inships ─── inships

6、amidships ─── adv.在船腹;在船中部

7、airships ─── n.飞艇

8、amidship ─── adj.在船中部的;adv.在(接近)(船)中部

9、endships ─── 末梢

midships 常见例句(双语使用场景)

1、Optimization of Midship Section Structure of Large Crude Oil Carrier Based on Genetic Algorithm ─── 大型油船中剖面结构优化设计的遗传算法

2、midship optimum design ─── 中剖面优化设计

3、Optimum design of midship sectional transverse members based on genetic algorithm ─── 基于遗传算法的油轮中剖面横构件优化设计

4、The thickness of side plates shall be approved by Classification Society.The thickness of steel plates from midship to both ends shall be applied as per rules of classification society. ─── 舷侧外板的厚度应经船级社认可,从船中部至船两端的外板厚度应满足规范要求。

5、On the design of midship section of 300 000 DWT VLCC ─── 300000dwt 超大型油船的中剖面设计

6、The weight of large crude oil carrier midship section structure is minimized with genetic algorithm based on DNV rules. ─── 本文采用遗传算法对大型油船中剖面结构进行了基于DNV规范的优化。

7、Keywords ship;VLCC;CSR;longitudinal strength;midship section design; ─── 船舶;超大型油船;结构共同规范;总纵强度;中剖面设计;

8、Good afternoon, Mr. Pilot. I am the captain. Now the Engine is dead slow ahead, midships. ─── 下午好,引航员先生。我是船长。现在船舶微速前进,正舵。

9、Side curtain, draw bar, midship axles! ─── 中国基本上无踪迹的东西们...

10、{0>Article 70 The shipping administration authority or the local government may, as it deems necessary to limit the draft of small ships, assign the maximum draft and mark it on both midship sides. ─── 第70条 航政主管机关或直辖市、县(市)政府,认为小船有限制吃水之必要者,得勘划最高吃水尺度,标明于船身中部两旁。

11、midship shaft bearing cover ─── 中间轴轴承盖

12、During the process of the midship section design, drawing and calculatingare carried through crossly; ─── 而且,随着结构设计阶段的发展,局部性结构设计不断深化,舯部结构的计算和图纸的绘制均不免要反复加以修改,直到彼此能相互准确呼应。

13、midship bulkhead ─── 中部舱壁

14、midship frame ─── 中部肋骨

15、large amounts of piping are to be seen on the deck running from the pump rooms to the discharge manifolds positioned an midships,port and starboard. ─── 很多管道系统将被看见在跑从泵房的甲板到放电多头管安置了船中央地,口岸和右舷。

16、hull midship section modulus ─── 船体中剖面模数

17、The optimization of the midship section structure of a large crude oil carrier with genetic algorithm based on DNV rules is introduced. ─── 摘要采用遗传算法对大型油船中剖面结构进行了基于DNV规范的优化。

18、Article 70 The shipping administration authority or the local government may, as it deems necessary to limit the draft of small ships, assign the maximum draft and mark it on both midship sides. ─── 第70条 航政主管机关或直辖市、县(市)政府,认为小船有限制吃水之必要者,得勘划最高吃水尺度,标明于船身中部两旁。

19、Keywords VLCC Design of midship section; ─── 关键词VLCC;中剖面设计;

20、area of midship section ─── [机] 中央横断面积

21、Distance from midship to center of floatation ─── 浮心距船中距离漂心距船中距离

22、The drain driving section was located at midship and multiple driving rigs were installed on the barges for plastic drain installation. ─── 打设船采用在船钟设打设区的结构,且采用多台成组的打设方式;

23、Moment of inertia of midship section ─── 舯剖面惯性矩

24、midship section ─── [船]船(体)中(段)断面图

25、midship coeficient ─── 船中系数

26、midship mounting ─── 中间支承

27、midship engine ─── 中置式发动机

28、Wherethe long bridge deck within 0.5 L amidships is regarded as strengthdeck, the midship section modulus and minimum thickness of the deckplating comply with the requirements of 2.2.1 and 2.4.2.l of this isChapter. ─── 例1:在船中部0.5L区域内的长桥楼甲板作为强力甲板时,其船中剖面模数及最小厚度应满足本章2.2.1及2.4.2.1的要求。

29、midship section design ─── 中剖面设计

30、The paper described a knowledge-based CAD system for the generation of containership midship sections, its principles and the process of its development. ─── 文中介绍了集装箱船中剖面生成基于知识的计算机辅助设计系统,及其基本原理。

31、midship frame space ─── 船中部肋骨间距

32、Keywords intermediate bearing;midship shaft;finite element analysis; ─── 轴承平衡支撑;中间接轴;有限元分析;

33、Midships Rudder to be held in the fore and aft position. ─── 1正舵舵保持在船首尾线位置上。

34、Nishihara S.Ultimate longitudinal strength of midship cross section.Naval Arch.& Ocean Engng,1984(22):200-214 ─── 马志敏.船体梁极限强度分析.武汉:武汉理工大学交通学院,2003

35、midship deep tank aft. ─── 船中后深舱

36、It is also better to stay in midship than at the bow or stern because that is where the sea swell is less pronounced. ─── 还有,你最好待在船中间的位置,避免待在船头或船尾,因为中间的位置海浪不那么强烈。

37、The weight of midship section structure for large crude oil carrier is minimized based on DNV rules. ─── 摘要基于DNV规范对大型油船中剖面结构进行了优化设计。

38、Midship cannoneers,sight the masts. ─── |中央炮手 瞄准敌人的主桅!

39、double barrel midship pump ─── 双筒船中部抽水泵

40、Midship section design is a vital step among ship's design. ─── 船舯所受弯矩最大,是全船结构主要矛盾之所在,组成了船体结构的全局性构想,因而是船舶设计的重中之重。

41、Distance from Midship to Center of Buoyancy ─── 浮标中心距船体中央距离

42、Keywords Oil tanker;Common Structural Rules;Load Calculating;Midship Section;Buckling Strength;Finite Element; ─── 油船;共同结构规范;载荷计算;中横剖面;屈曲强度;有限元;

43、midship shaft bearing ─── 中间轴轴承

44、Advances in the optimum design of the oil tanker in China are reviewed, including the longitudinal component of the midship section, the transverse component and the transverse bulkhead. ─── 从中剖面纵向构件优化设计、横向构件优化设计及横舱壁结构优化设计三方面评述了国内油船结构优化设计的现状;

45、Immersed Midship Section ─── 浸水船中剖面

46、Midships area coeff. ─── :船舯剖面系数。

47、After optimization of the midship section structure, the paper researches on optimum design of large crude oil tanker transverse bulkhead structure based on DNV rules. ─── 在中剖面结构优化设计的基础上,本文研究了基于DNV规范的大型油船横舱壁结构优化设计。

48、The GT-R is loosely based on Nissan's flexible FM platform but it contains so many unique elements that engineers have a separate name for the platform - PM premium midship. ─── GT的-R是日产的基础上松散的灵活调频平台,但它含有许多独特的内容,工程师有一个单独的名称该平台-下午溢价船中。

49、curve of area of midship section ─── 船体中段剖面面积曲线

50、So drawing andcalculating of the midship structure must be modificated again and again, untilthe perfect consistence between the data and graph is realized. ─── 特别是在手工设计为主的时期,浪费了大量的人力物力。

51、He has the responsibility and authority for preparation of hull initial drawings such as construction profile, midship section, shell expansion and etc. ─── 他有责任和权利准备船体初始图纸,像建筑轮廓,船体中央部分,船壳扩展等。

52、The ship to be arranged as a single decker. Machinery to be arranged midship and all accommodation forward. The ship to be dimensioned for a maximum draft (approx. 6,20 m). ─── 此船按单甲板布置,主机布置在船中部,所有的膳宿布置在船前面。在最大吃水条件下标注尺寸(大约6.2m)。

53、midship section coefficient ─── 舯剖面系数

54、In the center, in other words “midship” of these entrance areas, is the exhibition hall, which joins all the theatre foyers together. ─── 在中央,换句话说,在这两个入口区域的“船中央”是展览厅,它把剧院的所有休息室都连接起来。

55、midship tank ─── 中间水舱

56、midship the helm! ─── 正舵!正舵

57、Midship Section Area ─── 舯剖面面积

58、Casting Die Design of Midship Mounting on Heavy Duty Starters ─── 重型减速起动机中间支架压铸件模具设计

59、midship pump ─── 中置泵

版权声明: 本站仅提供信息存储空间服务,旨在传递更多信息,不拥有所有权,不承担相关法律责任,不代表本网赞同其观点和对其真实性负责。如因作品内容、版权和其它问题需要同本网联系的,请发送邮件至 举报,一经查实,本站将立刻删除。

猜你喜欢